its possible mine is different then, i do have the 35hr not the 37. I had one on each side. I think one side had a bleeder valve but the other was just a coupler. I have pics of both (broken)

 

Earlier models had a plastic "T-type" connector on the driver side that included the bleeder valve. My 2008 Coupe has one. My neighbors 2011 sedan does not.

I believe at some point (2010-ish?) these were phased out. If your car doesn't have a bleeder port, you likely just have a straight hose- and are way better off.

 

Yup just 1 connector on my 2012 Sedan. It does seem like if the car has a bleeder port, rather than a straight connector like mine, then it’s more likely to have 2 connectors. One on each side.

 

Finley getting this wrap done

 

Is there such a thing as a 1/3rd life crisis? I think I might be there.

Never had an aftermarket exhaust on any vehicle in my life. It has been small steps with long pauses in between to get to this point. I am excited for installation and finished product once installed. I think it will pair nicely with my FI RHFC.

 

ARK Grip and FI RFHC? Oh yeah, that's going to sound amazing. It will completely transform your drive.

 

New hood today! First person to ever install this hood. Ugly stock plenum but that will change.

 

Just finished wrapping my hood. How much material did you use for the front bumper?

 

Wife and I wrapped the hood. On my path to looking decent.

 

That's an interesting hood, Supra. It's really too bad the OEM plastic intake isn't more attractive. Do you have plans to swap out for an aftermarket intake now to really take advantage of the viewing window in the hood?

 

I used 12’ ft x 26” inches for the front bumper and 14’ ft x 40” inches for the rear bumper. All’s I gotta say is, don’t cheap out and buy crap material like I did. Are usually wrap with Avery, 3M or Oracle, all amazing products.............but I decided to try out this new “low tack” vinyl, cheetah wrap. All I can say without going on a complete rant, is save your money and wrap your ride in aluminum foil. I really can’t say enough about how much this vinyl is garbage. Lol I have to apologize, it’s been a very stressful in the garage.

 

Dropped the calipers off for powder coat today. I'm going with Illusion Blueberry. Does any one have any suggestions for brake assembly grease?

 

I use ARP fastener assembly lubricant, never none me wrong and I used it on all my desert race trucks

 

Thanks for the suggestion I'll check that out.

Another thing I did to the G this week... I replaced the plastic under shroud that was broken with a metal one from TBW. Sorry about the pea gravel reflection.

 

Let me know how that works out, I hear good and horror stories about them. I really wanna try one out