just ordered the Diode Dynamics 'tail as turn' plug&play kit for the sedans!!! Finally!!!

2009-2014 Infiniti G37 Sedan Tail as Turn? Module (Pair) - G37 Sedan - Infiniti - Products By Vehicle

 

That's awesome this is finally available for the sedans!

I finally vinyl wrapped this bad boy in 3M 1080 gloss black, took a few hours but well worth it!

 

Can anyone confirm that having this in the rear with the built in resistor will allow me to run an LED front turn signal without hyperblinking? I wouldn't need a resistor up front too?

 

I always rinse-foam and then bucket and mitt, I believe its the best way to wash my car.
I like to do it and its also a great way to get a feel any transparent gue or sap of trees that may have stuck on. You also get to see any tiny tar that may have stuck on usually on lower front side door panel's and fenders or rear lower bumper.

And all in all the satisfaction I get from a personal car wash is unmatched to any commercial car wash.

Thanks

 

I've just ordered mine! They've made the installation plug-n-play!

 

^way to go! I've been emailing DD the past few weeks and just happened to log into their site and saw it available....

...I was always envious of the modern sedans with LED rear turn turn signals, now we got them!!

 

agreed! I'd purchased two of the coupe versions last year, but have been hesitant to install it. I've since given one away at the PA meet last month. The other is still in my trunk.

However, now that the sedan version has been released, I can finally move forward with this mod.

 

Peeled off the plasti dip from my winter setup. Sanded, primed, and painted them with duplicolor bronze wheel paint

 

Nice color choice Swen, look forward to the installed photos. How many cans and coats did you use and did you clear coat them too? Looks good!

 

Thanks. Yes I clear coated them. 2 cans of primer for all wheels. 4 cans of paint, one for each. 2 cans of clearcoat for all the wheels. Approximately 3 light coats of primer and 2 heavy coats. Same with the paint. 3 light and 1 heavier coat with the clear coat

 

I like them, I owned a set of Red Rays lugs, just be warned...the finish on them wear extremely easy! Avoid taking rims off as much as you can. My red lugs quickly wore away.


Also installed my boot and **** this weekend

 

Be careful what you wish for. 😬

Project Practicality

 

Nice job on that boot & **** combo DFS, really tied together very well!

 

I like the matching color boot thread to the little blue turtle. Didn't realize that **** came in blue... only ever seen it red. Very nice. Not too fond of the stitching pattern, but the color is a good match, IMO.

Have you considered staining the seat threads blue? I wonder if that would work together, or be too over the top. Problem is (and AFAIK), it's a one-way decision.

No boot ring under the ****? That seems awkward.

Oh hey... I just researched the Tommy Kaira **** a little bit, and realized the emblem comes in a variety of colors. Go figure.

 

Mannnnnnnn you guys are making me miss my car with all of this progress you're making... I feel like I'm slacking.

I feel like I get new ideas everyday though, along with other ways to drain my bank account.