What did you do to your Sedan today?
#6361
Registered Member
It’s only been 1 week since I bought my 2nd G, and I’ve already done a bunch for her.
- GT-R Start Button
- GT-R Map Lights
- Wrapped the Badly Worn Steering Wheel
- All new Interior LED’s, Trunk LED and License Plate LED’s from Diode Dynamics
- New Interior Aluminum Trim on the Drivers Side Front Door
- Replaced the Drivers Side Mirror
- Q60S Shift **** and Boot
- GT-R Start Button
- GT-R Map Lights
- Wrapped the Badly Worn Steering Wheel
- All new Interior LED’s, Trunk LED and License Plate LED’s from Diode Dynamics
- New Interior Aluminum Trim on the Drivers Side Front Door
- Replaced the Drivers Side Mirror
- Q60S Shift **** and Boot
Thanks!
Eric
The following users liked this post:
Diode Dynamics (03-04-2019)
#6363
#6364
#6366
Registered Member
Got high flow cats and the XYZ installed. Demon bolt was way harder than the Z but everything came apart.
ZdayZ prep has begun. Brakes, a Y back exhaust, fresh powder on the wheels and a tune are up next
ZdayZ prep has begun. Brakes, a Y back exhaust, fresh powder on the wheels and a tune are up next
The following users liked this post:
Diode Dynamics (03-05-2019)
#6368
Registered Member
Remote start installed, I disabled the horn after taking the video. 6/10 install just because of the 3 wire that need spliced and soldered. Took me 5 hour or so, wish I'd done it sooner.
#6370
It’s only been 1 week since I bought my 2nd G, and I’ve already done a bunch for her.
- GT-R Start Button
- GT-R Map Lights
- Wrapped the Badly Worn Steering Wheel
- All new Interior LED’s, Trunk LED and License Plate LED’s from Diode Dynamics
- New Interior Aluminum Trim on the Drivers Side Front Door
- Replaced the Drivers Side Mirror
- Q60S Shift **** and Boot
- GT-R Start Button
- GT-R Map Lights
- Wrapped the Badly Worn Steering Wheel
- All new Interior LED’s, Trunk LED and License Plate LED’s from Diode Dynamics
- New Interior Aluminum Trim on the Drivers Side Front Door
- Replaced the Drivers Side Mirror
- Q60S Shift **** and Boot
#6371
Registered Member
https://cdn02.fortin.ca/en/download/24031/24031.pdf
all 3 are on page 4
#6372
The boot itself comes on a frame that fits the Q60, so the leather needs to be removed from the Q60 boot and fit to the G37 frame. It wasn’t terribly hard to do.
I don’t see any height difference, to be honest. I absolutely love the new ****. My post further up in the chain has pictures comparing the **** heights.
#6373
Registered Member
iTrader: (8)
It was the Fortin evo-nist1, had 1 on the starter button, one by the fuse box for the parking lights and 1 at the BCM in the passenger kick panel for the door pin.
https://cdn02.fortin.ca/en/download/24031/24031.pdf
all 3 are on page 4
https://cdn02.fortin.ca/en/download/24031/24031.pdf
all 3 are on page 4
The following users liked this post:
-ZS-Carpenter (03-05-2019)
#6375
Registered Member
I won these in a raffle. Just installed them today. You can't tell from the picture or video but it's a red & amber switchback ring.
parking mode = rings are red LEDs
turn signal = rings blink bright amber
brakes = uses the factory led dots
Parking mode red rings
Turn signal bright amber
My factory taillights with GTR overlay cutout.
parking mode = rings are red LEDs
turn signal = rings blink bright amber
brakes = uses the factory led dots
Parking mode red rings
Turn signal bright amber
My factory taillights with GTR overlay cutout.