they use a phone book between their fender and wheel and then jump in the car to make the phone book roll/pull the fender.


How do I know this? because I did it to my G

 

Or jack it up, insert the phone book, and then then just release the jack lol did you really use the phone book trick? How did it come out?

 

I used a jack and a steel pipe to roll the fenders on my old accord. I ended up with bacon fenders. Looked like sh*t, but I did get hungry every time I looked at it. Mmmm bacon.

 

....

 

Bacon fender... that's actually a thing. Oh google...

I saw a beautiful 5th Gen Prelude yesterday and I wanted it. Such a pretty little car.

 

What's a phone book? I have a contact list which is basically the same thing right?

 

yeah that's exactly what we did we just jumped in the trunk a few times to make sure we got the fenders were totally taken care of.


It actually worked out really well better than the baseball bat method

 

That's pretty awesome. I've seen good results from a lot of different methods. Also saw a lot of bad results though haha

 

Sad thing is you see them on cars that people invested a lot of money into... then tried to save a few pennies comparatively on the fenders.

 

Yea very true!

I may have asked this before but I can't remember. What do you guys think about Nissan emblems. I'm trying to figure out something to do with the rear emblem and the front grill/emblem but I can't really decide.

I almost want to go mesh up front with an offset lower case g and then just leave the Infiniti logo on the back like it is now, but lower on the trunk. More centered. Not necessary lower.

 

Check out STownSaint's CMOD grille... looks good in black, because the fitment isn't perfect. Also, without something in the middle, you've got that vertical support which looks goofy. Notice he used the big Fuji off the FX.



Regarding the centered trunk Fuji... here, this is a mock-up:



Notice how the Fuji is lowered so that it is proportionately centered between the line at the bottom of the trunk spoiler, and the crease that runs between the tail-lights. It's about a 1" drop, maybe less.

 

What's your address, I'll send you one.

Oh, wait, you like in Canuckistan. Canada Post blows dead polar bears -- it'll take 4EVER to get there. And you'll pay a ridiculous VAT for a small part of a dead tree.

 

Yea I was trying to refer to his grill but I couldn't remember his name to save my life lol I really like the results. The big Fuji looks ver proportional to the front end IMO. Looks awesome.

For the trunk emblem I was going to tape from one headlight to the other (same height) and place it there. But I was thinking about painting my emblems with some left over paint from my bike. It's called aluma blast from Eastwood. Cleared in automotive satin clear coat. I stole these from my Instagram. This is what I was going to paint the headlight housing trim and grill with too. But I changed my mind because of my next wheel purchase. Going to run polished lips. Square setup. Aggressive fitment. But not aggressive enough to roll and stretch

 

Getting tuned today via ecutek... WOOT WOOT

 

You should have Sebastian do it. I hear he's quite god...

Sean