mcola

I partly used this DIY to install my Fortin EVO-NIST1 that I'm struggling to get to actually start my car, despite believing I have it properly flashed, installed and programmed. So tracing and retracing my steps, I'm wondering about the brake sensor switch that I removed to change swap the connectors. It seems like but design, it can be installed at any height. Unfortunately I did not mark its height before removal. Any idea how to know what height to install it at? Thanks

Redgoyabean

Redgoyabean

Can anyone tell me which t-harness they used, I have the dball2 but it shows 2 types of t-harnesses on xpresskit.com

flipmode007

By any chance did you figure it out ? I know its an old thread

Redgoyabean

No, I simple had a shop do all the work n connected it to a viper smart start. Love it.

flipmode007

Ah man sorry to hear that, but glad you love it

Redgoyabean

Yea think it was may 80 bucks so yea love it