I would not recommend running 295s with a low offset like +23 as there will be rubbing on the fender liner and the fender bolt. Also you have to be dropped quite a bit for them not to stick out in the first place. There are members running this setup however they have other things going on that helps them in fitting a wide tire. e.g camber below -3 degrees, coils, shaved fender bolt, fender pull etc...

 

thats a lot going on. I have a full camber Front and Rear. I guess I might have to shave. but pulling is a bit too much for me...

 

Like sunny said you can make it fit. But if your buying high quality expensive tires you probably wouldn't want to run that set up, your going to have to run significant camber to make it fit dude.

 

Yea I'm rocking some pzero corsas (about 600 a tire... ). Dang maybe I'll go witha smaller tie and poke a little?

 

You'l be good with a 265/30 at factory camber and toe specs or close to it, and you can still be slammed. All u have to do is shave the bumper bracket and trim the liner. I had my gt30's at +22 with that exact set up.

 

cool man, thanks for the heads up. I'll probably look into doing that then.

 

Good luck, post pics when you get it set up.