Is there a manual or anything that shows you how to take the back lights off...i wanna get mines tinted

 

are you doing overlays or spraying them? i think someone has a diy on this... search for it

 

Its simple, pull up on the plastic piece where the trunk latch is, undo the carpet clips around where the lights are, and unbolt 3 nuts on each light. Should be 8mm nuts.

 

I took the 3 screws off but i think its something else holding it up...2 lil ***** on the outter ends

 

after you take the 3 screws off, yes there is 2 pieces holding the light in.

You can either:
1. Grab the light and pull it straight back, mad hard.
2. From the inside, find the piece thats clipped in, put something against it like a small pipe or something, and hit the end of that lightly to pop the clip out.

Its not really that hard, its just clipped in there pretty good. I did the second one i wrote and it worked fine, much easier than pulling on that sucker for awhile.

 

mallet on the screw tops ftw

 

https://www.myg37.com/forums/faq-and...aillights.html

 

Getting rear-ended doesnt work that well fyi. At this point, id be happy with a stock working tail light.

 

check the DIY section... i think Ivoidwarranties posted the link... its a piece of cake... easy mod to do !