Bose Audio Wiring Breakdown
anyone have a detailed lay out of the g37 sedan wiring? Or even better, what wire colors are needed for Right Rear +/- and Left rear +/-. Also what wire to tap for amp REMOTE? *Sorry if this is covered elsewhere..I'm at this thread
Here's a wiring breakdown for the Bose amp and Woofer amp. Please note that wiring color may not be the same at the speakers. These are for at the amp only and the pin number reflects the harness seen from where the wires go in, not the terminal side.
Bose Amp
Harness B42 (Pin Number/Item/Color Code)
(1) Front Left Mid/Tweeter + (L)(Blue)
(2) Front Left Mid/Tweeter - (W)(White)
(3) Front Right Mid/Tweeter - (LG)(Light Green)
(4) Front Right Mid/Tweeter + (V)(Violet)
(5) Front Right Woofer + (G)(Green)
(6) Front Right Woofer - (R)(Red)
(9) Front Left Woofer - (W)(White)
(14) Front Left Woofer + (B)(Black)
(10) Power/Key (Y)(Yellow)
(11) Power/Constant (GR)(Grey)
(12) Ground (B)(Black)
Harness B41 (Pin Number/Item/Color Code)
(16) Rear Woofer + (SB)(Sky Blue) **Signal to woofer amp
(17) Rear Woofer - (V)(Violet) **Signal to woofer amp
(18) Rear Left Mid + (L)(Blue)
(19) Rear Left Mid - (P)(Pink)
(23) Rear Left - (SB)(Sky Blue) **Preamp from HU
(24) Rear Left + (V)(Violet) **Preamp from HU
(25) Rear Right - (Y)(Yellow) **Preamp from HU
(26) Rear Right + (BR)(Brown) **Preamp from HU
(29) Center + (L)(Blue)
(30) Center - (O)(Orange)
(31) Rear Right Mid + (LG)(Light Green)
(32) Rear Right Mid - (Y)(Yellow)
(33) Front Right + (R)(Red) **Preamp from HU
(34) Front Right - (G)(Green) **Preamp from HU
(35) Front Left + (P)(Pink) **Preamp from HU
(36) Front Left - (L)(Blue) **Preamp from HU
(20) Power/Amp On (W)(White)
Woofer Amp
Bose Amp
Harness B42 (Pin Number/Item/Color Code)
(1) Front Left Mid/Tweeter + (L)(Blue)
(2) Front Left Mid/Tweeter - (W)(White)
(3) Front Right Mid/Tweeter - (LG)(Light Green)
(4) Front Right Mid/Tweeter + (V)(Violet)
(5) Front Right Woofer + (G)(Green)
(6) Front Right Woofer - (R)(Red)
(9) Front Left Woofer - (W)(White)
(14) Front Left Woofer + (B)(Black)
(10) Power/Key (Y)(Yellow)
(11) Power/Constant (GR)(Grey)
(12) Ground (B)(Black)
Harness B41 (Pin Number/Item/Color Code)
(16) Rear Woofer + (SB)(Sky Blue) **Signal to woofer amp
(17) Rear Woofer - (V)(Violet) **Signal to woofer amp
(18) Rear Left Mid + (L)(Blue)
(19) Rear Left Mid - (P)(Pink)
(23) Rear Left - (SB)(Sky Blue) **Preamp from HU
(24) Rear Left + (V)(Violet) **Preamp from HU
(25) Rear Right - (Y)(Yellow) **Preamp from HU
(26) Rear Right + (BR)(Brown) **Preamp from HU
(29) Center + (L)(Blue)
(30) Center - (O)(Orange)
(31) Rear Right Mid + (LG)(Light Green)
(32) Rear Right Mid - (Y)(Yellow)
(33) Front Right + (R)(Red) **Preamp from HU
(34) Front Right - (G)(Green) **Preamp from HU
(35) Front Left + (P)(Pink) **Preamp from HU
(36) Front Left - (L)(Blue) **Preamp from HU
(20) Power/Amp On (W)(White)
Woofer Amp
(23) Rear Left - (SB)(Sky Blue) **Preamp from HU
(24) Rear Left + (V)(Violet) **Preamp from HU
(25) Rear Right - (Y)(Yellow) **Preamp from HU
(26) Rear Right + (BR)(Brown) **Preamp from HU
(33) Front Right + (R)(Red) **Preamp from HU
(34) Front Right - (G)(Green) **Preamp from HU
(35) Front Left + (P)(Pink) **Preamp from HU
(36) Front Left - (L)(Blue) **Preamp from HU
in other words, there is a balanced (+ and-) coming from the headunit / nav unit that exits at the connector to the amplifier at the above pins, right?
then, if i want to use the stock wiring to connect the outputs from my new amp to the factory speaker harness, i use these:?
(1) Front Left Mid/Tweeter + (L)(Blue)
(2) Front Left Mid/Tweeter - (W)(White)
(3) Front Right Mid/Tweeter - (LG)(Light Green)
(4) Front Right Mid/Tweeter + (V)(Violet)
(5) Front Right Woofer + (G)(Green)
(6) Front Right Woofer - (R)(Red)
(9) Front Left Woofer - (W)(White)
(14) Front Left Woofer + (B)(Black)
(18) Rear Left Mid + (L)(Blue)
(19) Rear Left Mid - (P)(Pink)
(29) Center + (L)(Blue)
(30) Center - (O)(Orange)
(31) Rear Right Mid + (LG)(Light Green)
(32) Rear Right Mid - (Y)(Yellow)
is that correct?
thanks much! i am setting up a rather high powered and advanced system using the factory locations (other than the sub, as i will be using 2 12" subs in a small box) and a JBl MS-8 processor. i do not want to cut any wires and want to keep the install as stealth and reversible as possible ...
p.s.
which is the remote turn on lead? this
(10) Power/Key (Y)(Yellow)
or this
(20) Power/Amp On (W)(White)
thanks again!!! pics and log to come!!
I'm trying to find the passenger side wires for the Right Front woofer in the passenger side kick panel and I am having no luck. These wires (output from the bose amp, are Green (+) and Red (-). I see the Driver side woofer wires Black(+) and White (-), in the driver side kick, but I also see Red and Green in that same bundle on the driver's side. Does anyone know if these wires travel under the dash, all the way across to the passenger side Molex?
If you are running a serious aftermarket amp set up, you will need to run higher gauge power distribution.


