lol thanks..
Yeah dropped on stance True coils
SPC camber arms
no fender work at all, was running about -5 on the rear and -1 toe
front was fine since was not too aggressive ..

 

Thats what im getting stance coils just didnt order the camber arms my buddy was telling me i wasnt really going to need it for the rear and he's running 20x10 front and 20x11 rear

But Your running 9.5 ? In the front with what offset ?
Just wondering you think 10.5 would fit like the back does up front? Or I'd have to mess with fender rolling Wich isint an issue just need some pointers I'm used to modding civics where nothing really fits lol

 

front were +12 and rears +22

IF your planning on going as low as me then yes you need cambers, it wont fit lol
And if you don't use camber then you will need major fender roll
And you can only pull so much before fenders start flaring, but its all up 2 the driver lol
flares are FTL lol
And also remember im driving a sedan not a coupe lol I habe smaller gap too

 

yeah ill probably be going as low as you so camber arms it is then
you didnt need the camber kit in the front did you?
lol yeah i dont want my fenders looking like crap im trying to minimize body work on the car..
yeah mines a sedan too. but these socal streets are a pain in the a** sometimes. lol

 

Where in socal are you posted at ?
Im near downey lol and yes agree streets are **** here

yes get rear cambers and toe bolts and you should pull it off

 

What offset is he running with that 20x11? Been wondering the highest offset I can run to minimize camber to make 20x11 fit... Hmmmm...

 

ohh nice man not that far i live In the South Bay area by Torrance bro.

perfect ill do that then ill post pictures on here when i get everything
fitted and ready to go.

 

yeah he must have a 20x11 with super high offset no way that will fit with low numbers lol
Or must be at almost stock suspension springs so it wont hit fenders

 

id have to ask him but i think hes running +25 or something in those specs
but he had to do some minor pulling on his quarters i cant really remeber his specs.

sorry typo i ment +35

 

19x9 -5 215/35
19x11 +6 235/35




19x10 +8 215/35
19x11 +14 245/35

 

DAyyaaamm on Equips that's FTMFW lol ..
First sedan I seen them rock and Legit offsets lol

are you on air ?

 

Hey quick question... will 20x11 +35 work in the rear of a sedan with BBK??... probably going to run 275/30... is that workable?? Any issues I might run into? Thanks in advance!

 

Depends how low are you, or trying to go. but might need some pull, wheel is big for OEM fenders

 

Good mornin' every1. Quick question. Getting Vossens install today....wondering if it would require a fender pull. Getting the vfs2 satin bronze in 20x9+32 and 20x10.5 +45 with 245/35/20 & 275/30/20 . With stance coilovers & spc F + R camber kit. Can I go 25.75" or 26" all around or how low b4 fender pull required?

 

it all depends how low you are and how low your trying to be
your going to have to try to find out yourself when you install them