I am assuming the light was not a issue before this fiasco ensued? Because you likely did not disconnect the battery when you removed the preset switch panel (the clock one) to replace the amp, this is why the SRS light is blinking/ on.

Here are the SRS Light Reset instructions. This works 99.9% of the time.

If the issue persists, and there is a known pre-existing event, you might need to have the issue looked at by a reputable mechanic.

 

It work, no more airbag :-) now I just filled up the gas tank and I just need to run a little bit to make sure the needle goes down.

Hopefully now everything is good. If the needle doesn’t go down, I don’t know if it’s possible that I purchased a bad used parts for that a/c part

we shall see!!

thank you again, everybody..

 

mmm hmmm... You just want a excuse to zip around town all good.