Hey guys, so I was turning into a driveway from a main road and there was a speed bump like bump but it was thin and was no marked so I didn't see it. Went over it too fast and scraped the **** out of my bottom. As soon as I hit it I smelled something burning, windows were up. I checked under the car and near or above the ypipe theres this white wire hanging. both ends connected to something. Does anyone know what this could be?
Thanks

 

Oxygen sensor wires.

 

need pic to verify

 

will there be any problems?

 

It should be clipped onto that u shipped brace. If the clip is broken I would suggest a zip tie to keep it from snagging on road debris and ruining a $200 o2 sensor.

 

i checked it had the pointy clip and i saw that there was a little gap, so I assumed it goes in there, so I pushed it in but idk if that pointy clip went in.

 

There are two of those, one on either side. Get under your car an look at them. Then put it in exactly the same relative position as the one on the other side that isn't hanging down. It's not hard.