performance Ideas
The exhuast is a ARK exhaust I'm good there. I was looking at coils from ark and wasn't sure if I should stick with ARK for most of that.
Trending Topics
how about lose some weight? i don't mean the OP (unless that's an issue), but remove the spare tire, floor mats, portable electronics and all other miscellaneous crap that weighs a car down. and go with a 1/3 tank of fuel. i bet it all adds up to 100+ lbs easy. that equates to 0.1s in the 1/4 mile - because i assume this "race" was at the track. and at 100mph, 0.1s equals one full car length which is considerable.
as mentioned above, sticky summer tires are a huge factor for a solid launch. intakes and exhaust will not make a noticeable improvement unless part of a more extensive mod list for performance (not just looks and sound). other than that, make sure all your maintenance is up to date, and change the air filters.
i did all the above when at the track a while back. thought i was clever until my buddy said he'd done the exact same thing.
as mentioned above, sticky summer tires are a huge factor for a solid launch. intakes and exhaust will not make a noticeable improvement unless part of a more extensive mod list for performance (not just looks and sound). other than that, make sure all your maintenance is up to date, and change the air filters.
i did all the above when at the track a while back. thought i was clever until my buddy said he'd done the exact same thing.
Last edited by canucklehead; Apr 15, 2015 at 03:59 PM.
Coils as in plasma coils, not coil overs.
I'd imagine if you mod the coils then you'd also want to go FI.
But you said little race, so sweat the small stuff? IF it's pride and ego then get that wallet ready! GL.
I'd imagine if you mod the coils then you'd also want to go FI.
But you said little race, so sweat the small stuff? IF it's pride and ego then get that wallet ready! GL.
Thread
Thread Starter
Forum
Replies
Last Post
ZSpeedPerformance
Drivetrain
12
Sep 9, 2016 11:20 AM
ZSpeedPerformance
Supporting Vendors
0
Sep 4, 2015 11:09 AM



