Infiniti G37 - rattle at idle
#17
Registered Member
My heat shields were rattling pretty bad, tied em up and it solved my issue. I still get a rough idle sometimes, at about 600rpm my car goes rough. It sounds like the passenger cat shield might be loose, or the shields wrapping the exhaust? Give those a shot and see what happens. (I have a hole in my exhaust, so I can’t quite hear everything perfect in my car)
Thanks!
#18
Registered Member
Join Date: Apr 2018
Location: Asheville, NC
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
Check my thread, is it similar to this? Because mine is definitely not heat shields lol.
https://www.myg37.com/forums/engine-...tle-shake.html
https://www.myg37.com/forums/engine-...tle-shake.html
#20
Moderador
I chose a more "permanent" fix
The following users liked this post:
socketz67 (05-18-2023)
The following users liked this post:
socketz67 (05-18-2023)
#23
Super Moderator
I checked mine and it was really loose, replaced with a bumper push fastener as shown in your pic and it's snug now (see pic with PN below). Over the years, I have replaced so many of these clips under the hood and fender wells, which keeps vibration related rattles to a minimum. We could almost start a thread on the topic. I also use MD weather seal on alot of potential rattles (where high temps are not a concern, like the fuse/power line for my sub amp - see below) and to reseal things like the air boxes:
Additional question, the black cover that hides the battery has clips on the ends to hold in in place, but the center portion is plastic sitting on top of metal. Would that be a source of vibration related rattles?
Additional question, the black cover that hides the battery has clips on the ends to hold in in place, but the center portion is plastic sitting on top of metal. Would that be a source of vibration related rattles?
Last edited by socketz67; 05-18-2023 at 12:28 PM.
Thread
Thread Starter
Forum
Replies
Last Post
bill90879
Engine, Drivetrain & Forced-Induction
36
03-08-2013 01:46 AM
deep007
Engine, Drivetrain & Forced-Induction
8
02-07-2013 11:25 PM