Installed Stillen Grounding Kit
Thread Starter
No Soliciting
iTrader: (4)
Joined: Mar 2008
Posts: 818
Likes: 3
From: Miami (Oye Meng)
In my case, the supplied nut wasn't screwing on. So I just looked for another in my toolbox. I was already done with the whole installation and just had to finish connecting to the battery negative cable. By the way, the plastic engine cover has 2 nuts and 3 screws easily removed with a 10mm socket. The cover lifts right up. This was a very easily install and I'm no rocket scientist. Good luck.
Registered User
Joined: Nov 2004
Posts: 766
Likes: 0
From: DC/MD/VA
Registered User
Joined: May 2008
Posts: 448
Likes: 1
From: Northern Virginia
Former Sponsor
Joined: Dec 2007
Posts: 211
Likes: 3
Hey guys,
Thank you very much for the great review and interest. We are looking at putting together a group buy price on these right now. I will have more information in the next day or two regarding that topic.
To answer some of your questions. It doesn't look like we cover as many grounding points as some of the other companies because we try to use a harness style connector rather than individual wires. This makes installation a lot easier and in our opinion, makes for a much cleaner and less cluttered engine bay.
Thank you very much for the great review and interest. We are looking at putting together a group buy price on these right now. I will have more information in the next day or two regarding that topic.
To answer some of your questions. It doesn't look like we cover as many grounding points as some of the other companies because we try to use a harness style connector rather than individual wires. This makes installation a lot easier and in our opinion, makes for a much cleaner and less cluttered engine bay.
Former Sponsor
Joined: Dec 2007
Posts: 211
Likes: 3
In my case, the supplied nut wasn't screwing on. So I just looked for another in my toolbox. I was already done with the whole installation and just had to finish connecting to the battery negative cable. By the way, the plastic engine cover has 2 nuts and 3 screws easily removed with a 10mm socket. The cover lifts right up. This was a very easily install and I'm no rocket scientist. Good luck.
My email is kmillen@stillen.com
Thanks in advance!
Thread Starter
No Soliciting
iTrader: (4)
Joined: Mar 2008
Posts: 818
Likes: 3
From: Miami (Oye Meng)
This is very interesting. If you wouldn't mind sending me a picture or some type of description I would greatly appreciate it. If something is not fitting properly we need to address it immediately.
My email is kmillen@stillen.com
Thanks in advance!
My email is kmillen@stillen.com
Thanks in advance!
Former Sponsor
Joined: Dec 2007
Posts: 211
Likes: 3
Former Sponsor
Joined: Dec 2007
Posts: 211
Likes: 3
