Motive Bleeder doesn't hold pressure
Thread Starter
Registered User
Joined: Aug 2013
Posts: 72
Likes: 3
Motive Bleeder doesn't hold pressure
Own 2013 G37xS coupe.
Got a new Motive bleeder 0107. The cap fit nice , however it does not hold pressure (go down from 10 PSI to 5 after a few minutes).
Any advice???!!
Got a new Motive bleeder 0107. The cap fit nice , however it does not hold pressure (go down from 10 PSI to 5 after a few minutes).
Any advice???!!
Last edited by mbar; May 6, 2015 at 08:55 PM.
Thread Starter
Registered User
Joined: Aug 2013
Posts: 72
Likes: 3
)
Thread Starter
Registered User
Joined: Aug 2013
Posts: 72
Likes: 3
Got a replacement from Amazon and it had the same leak. I wonder if it's a bad batch....
Anyway I added some Teflon tape around the screw connection and that solved the leak.
Interesting information: the kit comes with a second o ring which is slightly thinner. This o ring (thinner) fits much better to the master cylinder.
Anyway I added some Teflon tape around the screw connection and that solved the leak.
Interesting information: the kit comes with a second o ring which is slightly thinner. This o ring (thinner) fits much better to the master cylinder.
Thread
Thread Starter
Forum
Replies
Last Post
blnewt
D.I.Y. Installations/Modifications
37
Oct 17, 2020 11:12 AM
Tuckermaclain
G37 Sedan
59
Oct 5, 2015 11:41 PM