Attention All BC Racing Coilover Guys, Check your Rears--Possible Install Error...
Last edited by bboysteele; Jun 24, 2008 at 02:40 AM. Reason: Putting the image tag in so the pic shows in thread
Mine is a bit higher that that, its all the way raised almost. But it still rubs. The shocks should have no effect on the height, just the stability of the spring, which I can tell mine is definitely moving a bit. The tire is rubbing the fender liner, there is not even room for a finger between the tire and the liner.

Picture looks a bit high but the angle of the shot makes it look like that.

Picture looks a bit high but the angle of the shot makes it look like that.
Last edited by symalik; Jun 24, 2008 at 02:21 PM.
This whole BC Coilover crap is getting very old... Hopefully this is a lesson learned for those that jumped on the BCs. This is what you get for jumping on the first out... Quality Issues! If I had BCs on my G right now, I'd be pissed and ripping that **** off my car.
I'm done... Will not discuss further.
I'm done... Will not discuss further.
blackjack did, i made a comment about his post being useless and off no help to two separate threads, but regardless... back to topic.
Do you still have the same rattle before and after Sharif re tightened everything?
Do you still have the same rattle before and after Sharif re tightened everything?
you guys should try driving around with your rear seat let down.. you should be able to hear the sound better then, and maybe get a better idea of what it could be
i'd buckle the rear seat belts in too if you try it
i'd buckle the rear seat belts in too if you try it
Thread Starter
Super Moderator w/ Boost
iTrader: (3)
Joined: Dec 2007
Posts: 7,042
Likes: 5
From: Knoxville TN
Rattle was there when Sharif Test Drove it after install... We thought it was the other suspension parts in the trunk or my amp that was loosely mounted in the tire well... but... it never went away....
EDIT: Nope nothing, same sound with the seat down and seat belts covered in shirts. I am going to try removing the sub box next and see maybe that's the cause.
Last edited by symalik; Jun 25, 2008 at 09:04 PM.
How come we didnt get this circled piece with our kits? That might help.

That will also help me raise the car a bit, because the rubber piece on the bottom is so thin, these springs are meant to be put on this, not the stock rubber piece I think.
And they look like they would fit fine if you look in this picture, they are not flat on the bottom, they are shaped just like the rubber piece.


That will also help me raise the car a bit, because the rubber piece on the bottom is so thin, these springs are meant to be put on this, not the stock rubber piece I think.
And they look like they would fit fine if you look in this picture, they are not flat on the bottom, they are shaped just like the rubber piece.




