Hello Everyone,

I have a question for anyone knowledgeable in repairing their dashboard. I have a few deep cuts needing repair. I was looking to either:

1. Replace the entire dashboard. (very $$$ and don't know if the airbags need to be changed)

2. Use a vinyl wrap over the cuts. (less $$$, not too much info)

3. Currently used a $5 vinyl repair kit but it didn't turn out very good.

Any recommendations?

Any help is greatly appreciated!

 

Any luck on this? I have an 11 sedan and was messing around with ideas on where to mount a cell phone holder....long story, but I ended up inserting the holding piece(thin metal) right above the nav display , there is a fine gap that I was planning to use, I ended up pilling out a 1/4 piece thatjust fell out, no force used etc , it just came out, so hoping for some solutions as well other that replacement.

 

I have a MINT black dash - from my part out thread. If you are interested - shipping is $$$ but I will sell for cheap. Only main part left in the interior that I have yet to remove...

I will include the pass. side airbag, but it is not needed. It sits close to the dash, and basically pops through the location.

 

Where are you located? Pm me with shipping costs might be interested if it's not too crazy. I'm in 32257. This sticky dash nonsense is driving me crazy

 

I'm located in Kitchener Ontario Canada
Shipping alone is $250

What is your offer?