Tried installing front turn signals from Diode Dynamics.

Decided to try living with the hyperblinking as I had tried splicing the load resistor (tapped the green/black and green/white wires), but it still hyperblinked and made my brake lights flash.

Removed the load resistor and placed electrical tape over the splice.

I proceeded to install the passenger side led bulb and it tested out fine. While on a drive just now, noticed the turn signal were not flashing (stays lit). Turned on my hazards and noticed they flash when I turn off the headlights. How can I fix this?

Edit
Was able to find the stock bulbs and replaced the LED bulbs with those. It is working as normal.

Just realised I bought the wrong bulb from Diode Dynamics (2009 Front Turn Signal)...