hey guys im going to start doing the 2011 non sport fog light conversion to my 2008 G37s now my question is this. how would i wire the bosch plug pigtails if i wanted to eliminate the fog light from the factory position and just run the fogs in the bumper using the factory switch. thanks for any help guys.

 

The stock housing has 2 wires that powers the fog. Yellow is + black is -. Theres a few ways you can connect that. You can either cut off the disconnect and pull the wires out through the foglight cover or just simply tap those 2 wires and route it to your pig tail. But be sure to remove the bulb and tape up the disconnect if you're planning on tapping the wires.

 

Hey man I can help u just hit me up it's easy u just need to purchase the PT120 pigtails from amazon.com it comes w 2 butt connectors and all u will need to do is connect the yellow and black wires from oem fogs and u will be good !

 

@ weiboy thanks for that info
@ vossen will do buddy ill hit you up when i get all the stuff for the conversion