Calling nav swappers
The confusion is that during playback, UP skips to the next station/track and DOWN is previous...,BUT, when scrolling through a station/track list, UP is previous while DOWN is next.
Registered Member
Joined: Aug 2009
Posts: 17
Likes: 0
Got it. I was probably overthinking it... Although I hate it when software devs aren't consistent (note: i'm a SW dev)
Registered Member
Joined: Aug 2009
Posts: 17
Likes: 0
Not sure how much help I can provide as I have a 2018 steering wheel, but, looking over my notes there are only three (3) wires going from the headunit to the steering wheel switches:
You may want to double check that you have those three (3) wires in the right place.
HOWEVER, as was mentioned previously, you should have a 2010+ preset switch assembly ("faceplate") to match your headunit. This could be the cause of your issues. I doubt your steering switches are the problem as, like I said earlier, I have a 2018 steering wheel and those switches work fine with the 2014 headunit.
Also, UP is for the NEXT track, DOWN is for previous. Always been this way AFAIK.
You may want to double check that you have those three (3) wires in the right place.
HOWEVER, as was mentioned previously, you should have a 2010+ preset switch assembly ("faceplate") to match your headunit. This could be the cause of your issues. I doubt your steering switches are the problem as, like I said earlier, I have a 2018 steering wheel and those switches work fine with the 2014 headunit.
Also, UP is for the NEXT track, DOWN is for previous. Always been this way AFAIK.
Thread
Thread Starter
Forum
Replies
Last Post
