krazyfiend

I wanted to show off the some of the end results of the original posters (bugfresh) product. Easily modified to allow the the original brake bulb to function for both turning and braking purposes (which I switched out to white LED bulb from TheRetrofitSource for no halogen delay when engaged).

Be it the plug and play iteration from DD or whatever method--imo It's a huge safety improvement in terms of additional visual presence when signaling. The oem setup during the daytime especially, can easily get lost in someones field of view and become unnoticeable to drivers following you imo.

No, I don't mind my plate being visible..

jman09

doesn't matter if its visible.

https://en.wikipedia.org/wiki/Driver...Protection_Act

and for entertainment value: Why Do We Always Blur License Plates On The Internet?

tailights looks nice.

Epiphany

What did you have to do to modify to make it all work together like that?

flipmode007

Any of you having this problem like me where the light blink faster for a couple of second and then go back normal to go back to blinking fast again?

Dreamerzcc

You have a resistor connected?

LED Resistor Kit - LED Resistors - Accessories - All Products

BaapsG37

Mine work just fine unless Im pressing the brake and have the turn signal on - when braking and having the turn on, I get a stutter in the turn signal. Its like BLINK ON, BLINK OFF, BLINK ON, STUTTER ON/OFF quickly, BLINK OFF, etc. Tried contacting Andy by email for support a while back, but haven't heard from him. Any clues how to fix?

BaapsG37

Are the ones for the sedans ready for sale?

kennyz424

iTrader: (147)

Thank you soooo much! I always wondered why this was but never cared enough to look it up call it laziness or lack of interest idk which but I'm glad I finally for answer for this

Ndanny

iTrader: (1)

Hi, are there any issues with the current modules with the built in resistors?

TrunkSlamchest

Anyone else have a lot of trouble getting the factory tail light connectors to release? Trying to install the Diode module and can't seem to get the tab they mention in the install video to unlock the connector.

Not sure if I'm just pressing on the wrong spot or if it needs more force (trying not to break them though).

Sway

is there a way to make the factory turn signal the dedicated brake light? and the rings go on with light switch engagement and flash brighter as rear turn signals? I have the triton V3's in the current factory rear turn signals which are plenty bright to be full time break lights.