Aftermarket Wheels - Anyone running Square Setup?
Registered User
Joined: Mar 2016
Posts: 11
Likes: 0
A 10+35 will limit what you can run since it will already be tight at the fender. And yes, you will want to lower your G as 20s don't look great at stock height.
If you don't want to do any fender mods a 255/35/20 all around is about as wide as you could run, and even then you may rub on the inside front fender under heavy compression. You'll be ok in back w/ those though.
If you don't want to do any fender mods a 255/35/20 all around is about as wide as you could run, and even then you may rub on the inside front fender under heavy compression. You'll be ok in back w/ those though.
What you might want to do is just get a pair of 255s and mount them up, then do a test fit in front to see if you like how they fit, TBH I wouldn't run a narrower tire on a 10" rim, it's been done but I wouldn't do it. If the 255s fit ok but may make contact on that front inner fender edge you could get that edge flat rolled like your rear fender. I think I would do that before running stretched 245s in front.
Thread
Thread Starter
Forum
Replies
Last Post