Thoughts on Rims and Tires?
Thread Starter
Registered User
iTrader: (1)
Joined: Jun 2012
Posts: 47
Likes: 1
From: Ellicott City, Md
Thoughts on Rims and Tires?
Hey Guys,
I am leaning towards these Stance ST1s, staggard set up of 20x8.5 et35 fronts and 20x10 et38 rear. My question is will this fit clear the Sport Sedan Akebono brake Caliper? Secondly, what is the most tire that I can get on these? I live in an area that is not very good at maintaining the roads. I am currently not lowered however I will want to lower in the future, most likely using a coilover.
Thank you in advance,
Grey
I am leaning towards these Stance ST1s, staggard set up of 20x8.5 et35 fronts and 20x10 et38 rear. My question is will this fit clear the Sport Sedan Akebono brake Caliper? Secondly, what is the most tire that I can get on these? I live in an area that is not very good at maintaining the roads. I am currently not lowered however I will want to lower in the future, most likely using a coilover.
Thank you in advance,
Grey
Hey Guys,
I am leaning towards these Stance ST1s, staggard set up of 20x8.5 et35 fronts and 20x10 et38 rear. My question is will this fit clear the Sport Sedan Akebono brake Caliper? Secondly, what is the most tire that I can get on these? I live in an area that is not very good at maintaining the roads. I am currently not lowered however I will want to lower in the future, most likely using a coilover.
Thank you in advance,
Grey
I am leaning towards these Stance ST1s, staggard set up of 20x8.5 et35 fronts and 20x10 et38 rear. My question is will this fit clear the Sport Sedan Akebono brake Caliper? Secondly, what is the most tire that I can get on these? I live in an area that is not very good at maintaining the roads. I am currently not lowered however I will want to lower in the future, most likely using a coilover.
Thank you in advance,
Grey
http://www.conceptzperformance.com/i...akeoutline.pdf
The +35 in front will be fine on a 245/35/20 and the rear will poke a bit w/ 275/30/20 but will tuck inside the fender under compression. That rear offset won't look right until it's dropped.
Thread
Thread Starter
Forum
Replies
Last Post



