But before I do, I have some questions.
Im lowered on BC coils and SPC camber kit F+R.

Im looking to run Vossen CV3s
F: 20x9 +20 with a 245/35
R: 20x10.5 + 25 with a 275/30

Will I have to shave the fender bracket to avoid rubbing? And how much camber should I expect to run?

Im looking for wheel gap similar to this, give or take a little

 

That's my car and I ran with -1.6/7 camber and shaved bracket! NO rubbing...

 

I sell Vossens at my new job, hmu!!

 

Hey I'm looking to get a set also. I just don't know where there is a dealer near me.

 

If you buy a used set from someone.. The warranty isn't transferable to the new buyer.

Trust me, I've emailed them before.

 

Ok but we're do I finde a dealer near me? I'm willing to bye new ones. So I can get the warrant. I'm located out side of philadelphia. I'm sry but I'm new to all of this.

 

PM me to locate a authorized dealer near your area.

 

^^^^ This!

Thanks for your interest in Vossen!

http://www.vossenwheels.com/CarGalle...VSCV3-524.aspx