I got my tires today they are falken 452 245/30 and 275/30. I have the CV1's with +20 and +25. I am dropped on H&R springs, really low. Has anyone on s-techs, h&r, or coils that are really low done this and if so do I need to know anything before hand? I shaved a little bit of my bracket. Anything else that I should know? I have my camber dialed in at around 1.8 will I need to adjust a bit. Or is this just going to be trial and error??? Thanks for your help..

 

Sounds like it's going to be super close, maybe all right with just you in the car!

 

Ya, hopefully it will work out.

 

I ran this setup with 086 and it was really close, you will have to shave the liner as well. I don't recall my negative camber settings but I was dropped on s techs.

 

Did you have falkens as well?

 

Kinda sux that G's have big hips and there's sum issues to run a low offset with a big tire...But anyways can't wait to see the outcome...Its going to look niceeeeee

 

you should be ok, just close i have +18/25 i was running -1.5 camber. I was using 255's though and was slammed the only thing i rubbed was the rear bumper bracket which i then took off. If you rub fender just adjust the camber accordingly you'll be allright. and post pics when its all said n done should look sick

 

I ran Federals 275/30/20

 

what tires did u have?/

 

Well here is what the Falkens looks like...

 

nice...........and nice car in the background haha

 

looks good .. its time to get coilovers and go lower....

 

Any rubbing issues ?

 

I am running the same exact tire with a 10.5" and +23 offset. I had to trim the liner, all but remove the bracket, and I am running normal camber (around -1.5). Very little rubbing unless I have a couple/few people in the car then it gets a little tricky.

 

Diego is looking to do this as well with I believe the same offsets.