Takeda Dyno - FWIW
you should ask them to redyno, i am assuming you paid. dynoing a cai with no air flow is kinda like dynoing an intercooler with no airflow, the gains of the cai are less about restriction and more about air temp.
I'm back on the dyno again tomorrow at 10:00am. I talked to the shop owner about our run and he said you "absolutely" have to use the blowers. Looks like tomorrow will be very similar to my May 22nd baseline pulls as well, so should have a much better comparison.
AZ - you're right I shouldnt have even bothered posting those bunk results - but I knew folks were waiting to hear.
Should have new results up around lunchtime tomorrow!
AZ - you're right I shouldnt have even bothered posting those bunk results - but I knew folks were waiting to hear.
Should have new results up around lunchtime tomorrow!
DAMN!! Are u serious? I did not turn it off, coming frm Driving a 90 GT 5.0 Supercharged Stang, I not sure if traction control aids of newer cars would have an effect on a Dyno? Guess I will half to do a re-dyno then huh! Maybe my VQ35HR will make more than 280WHP with it off? Since it's at 280WHP rite now...U think? ...LOL
^^^^ there's no way to dyno with it on. If you attempt to get the car up to speed the vdc locks up the wheels. It most likely was turned off without you knowing. And FYI, 280whp is normal.
...Also that 280WHP for a 07 G35 Sedan with the VQ35HR motor. not the VQ37HR Motor. and it's tuned with a Cobb AP.
It doesn't look like I can remove this thread, maybe a moderator can do it for us. So rather than edit all this bogus info I'm just starting a new thread and will post the link here.
Too late - just posted a new thread.
https://www.myg37.com/forums/intake-...ml#post3154649
I didn't want newcomers to have to read through all this garbage. Hopefully a MOD will remove this one - how do I contact one to request that?
https://www.myg37.com/forums/intake-...ml#post3154649
I didn't want newcomers to have to read through all this garbage. Hopefully a MOD will remove this one - how do I contact one to request that?
Mr. Drop it like it's hot
iTrader: (10)
Joined: Dec 2009
Posts: 6,135
Likes: 39
From: Lawrenceville, GA
Too late - just posted a new thread.
https://www.myg37.com/forums/intake-...ml#post3154649
I didn't want newcomers to have to read through all this garbage. Hopefully a MOD will remove this one - how do I contact one to request that?
https://www.myg37.com/forums/intake-...ml#post3154649
I didn't want newcomers to have to read through all this garbage. Hopefully a MOD will remove this one - how do I contact one to request that?
Thread
Thread Starter
Forum
Replies
Last Post
blnewt
D.I.Y. Installations/Modifications
37
Oct 17, 2020 11:12 AM




