And I decided to go with JWT...

Reasons:

Cost (cheap in comparison)
Gains (rather solid from independent dynos)
Ease of Installation (as noted by many)


The only thing I dont love is the look...But I'll be honest...I haven't opened my hood for anyone other then myself when cleaning the car so I decided that the look factor didn't matter to me...

My vehicle is a lease so I wanted an Intake that was an easy swap...I already have the Berk HFC's (I absolutely love them, except I have SES light) and I think the Borla will be purchased in the next couple of weeks...

Figure I can take everything off and sell them EXTREMELY dicounted to someone when my lease expires...Anyways thanks to everyone for the reviews and posts on various mods...I was on the fence and about to go with Stillen Gen 3 but the installation required a bit much...

 

awesome! congrats. post a review for us when you get a chance.

 

Same reasons why i bought mine. You're not going to be disappointed with these. And be sure to do a ECU reset after installing it.

 

Do a dyno

 

I did a before and after dyno when I had the Berks installed and those numbers essentially confirmed what we saw from Bboysteele...I'm not going to dyno after the intake install...But if I get the Borla I will be sure to Dyno the combo of Berk, Borla, JWT's for everyone to see...

Jay - Thanks for the advice...I'll be sure to do a reset...

 

Sounds good, enjoy the JWT's.

 

No problem brotha!

 

Congrats. I'm still on the fence with intakes and I can get these real cheap if I wanted them.
Can you give a quick review when you have them on?