I had the same issue with the right-side nozzle, I just used a pin to clean it, and it's back to normal now (the sprayer that is)

 

Use it for tailgaters. Either that or pop open the moon roof and hawk a lugie that lands on their windshield.

 

I had to take the vehicle in to the dealer for the Mass Air Flow sensor TSB and they fixed the sprayers too while it was there.

 

I didn't know the sprayers were supposed to be functional. Since I got the car, each sprayer only has one thin stream that shoots right over the top of the car. I have to tap the sprayer switch forward so it motor barely goes, in hopes that a few drops get on my windshield before the stream shoots over the car (all the way over onto the ground behind the trunk).

 

Holy Zombie Thread Batman. Hey the washer nozzle's aim is adjustable. The book says it takes a special tool and that you should "never use a needle or small pin". It then goes on to say that if there is wax or dust in the nozzle you should "clear it using a needle or small pin"...

 

Hello and welcome to the zombie thread.

I used a pin to poke my sprayer holes, I honestly never knew there were three per side. Now they work great, it's amazing! Three solid streams on each side, aiming right at the center of the windshield.