G37 Sedan

Code P2098 & P0300

Thread Tools
 
Search this Thread
 
Old Jun 12, 2022 | 11:57 PM
  #1  
d3r3k's Avatar
d3r3k
Thread Starter
Registered User
 
Joined: Jun 2022
Posts: 1
Likes: 0
Question Code P2098 & P0300

Modded 2013 G37x ECUTek tuned, been running fine with no problems since I purchased it at 48k miles, now at 65k. It came with the mods and tune.
Currently has: ECUTek Tune, TopSpeed Pro 1 Exhaust, Fast intensions resonated high flow cats, Stillen cold air intakes.

Have a had an engine service soon code off and on for a couple months now. I have tried to clean out my MAF sensors twice, I have replaced my downstream drivers side O2 sensor, and I have cleaned out my stillen intake filters.

Main code has been P2098 this entire time, and since having to daily it 30 miles to and then from work, its gotten progressively worse in the sense of a rougher idle, rumble and makes the car shake once or twice in my drive. Additionally the car sounds louder sharper but not in a good way. Car doesn't put down any power if I try and gas it, but it'll steadily climb. Exhaust flex pipe has some tears, one golf ball size whole in the flex pipe as well, so I am wondering if these problems are stemming from an exhaust leak. At this point I'm stumped, and I wouldn't even consider myself proficient and knowledgably enough to fix this myself, so I wanted to see if anyone has heard of these problems before and might know of a fix. Otherwise I am already planning on finding a local shop that will be able to access what is going on.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Wide boi
Intake and Exhaust
5
May 6, 2022 04:04 PM
ChrisGomez17
Engine, Drivetrain & Forced-Induction
1
Jan 7, 2020 09:14 PM
kennyG37x
Engine, Drivetrain & Forced-Induction
9
Jul 18, 2019 08:54 PM
el_donks
ECU Tuning / Dyno Data
6
May 16, 2016 11:33 AM
eddiealiano
Engine, Drivetrain & Forced-Induction
15
Dec 1, 2015 11:12 AM




All times are GMT -4. The time now is 04:06 AM.