What did you do to your Sedan today?
#8987
Registered Member
iTrader: (3)
Earlier models had a plastic "T-type" connector on the driver side that included the bleeder valve. My 2008 Coupe has one. My neighbors 2011 sedan does not.
I believe at some point (2010-ish?) these were phased out. If your car doesn't have a bleeder port, you likely just have a straight hose- and are way better off.
I believe at some point (2010-ish?) these were phased out. If your car doesn't have a bleeder port, you likely just have a straight hose- and are way better off.
#8990
Registered Member
Is there such a thing as a 1/3rd life crisis? I think I might be there.
Never had an aftermarket exhaust on any vehicle in my life. It has been small steps with long pauses in between to get to this point. I am excited for installation and finished product once installed. I think it will pair nicely with my FI RHFC.
Never had an aftermarket exhaust on any vehicle in my life. It has been small steps with long pauses in between to get to this point. I am excited for installation and finished product once installed. I think it will pair nicely with my FI RHFC.
The following users liked this post:
BloodLine_Prez (04-14-2022)
#8991
Administrator
iTrader: (9)
ARK Grip and FI RFHC? Oh yeah, that's going to sound amazing. It will completely transform your drive.
The following users liked this post:
ngolbuff (04-17-2022)
#8992
Registered Member
The following 3 users liked this post by SupraOfDoom:
#8993
Moderador
#8994
Moderador
Wife and I wrapped the hood. On my path to looking decent.
The following users liked this post:
Rochester (04-14-2022)
#8996
Registered Member
I used 12’ ft x 26” inches for the front bumper and 14’ ft x 40” inches for the rear bumper. All’s I gotta say is, don’t cheap out and buy crap material like I did. Are usually wrap with Avery, 3M or Oracle, all amazing products.............but I decided to try out this new “low tack” vinyl, cheetah wrap. All I can say without going on a complete rant, is save your money and wrap your ride in aluminum foil. I really can’t say enough about how much this vinyl is garbage. Lol I have to apologize, it’s been a very stressful in the garage.
#8997
Registered Member
Dropped the calipers off for powder coat today. I'm going with Illusion Blueberry. Does any one have any suggestions for brake assembly grease?
The following users liked this post:
FrogmanKouki (04-15-2022)
#8999
Registered Member
Another thing I did to the G this week... I replaced the plastic under shroud that was broken with a metal one from TBW. Sorry about the pea gravel reflection.
The following users liked this post:
BloodLine_Prez (04-15-2022)