speed bumps?
I had my 350z lowered about an inch, I'm used to avoiding all speed bumps and when I have to go over them, taking them at an angle... I would usually always scrape even when going at an angle... 
That got to be such a PITA, that I'm not dropping my G37S. I have only been over a couple of speed bumps since then(taken them at an agle as well) and have not scraped(knock on wood).
On a side note, I see that the two exhaust pips go under the rear axle... seems kinda out of place and possibly prone to a little scrapage. Not sure if the rear diff is lower than those pipes.
That got to be such a PITA, that I'm not dropping my G37S. I have only been over a couple of speed bumps since then(taken them at an agle as well) and have not scraped(knock on wood).

On a side note, I see that the two exhaust pips go under the rear axle... seems kinda out of place and possibly prone to a little scrapage. Not sure if the rear diff is lower than those pipes.
I had my 350z lowered about an inch, I'm used to avoiding all speed bumps and when I have to go over them, taking them at an angle... I would usually always scrape even when going at an angle... 
That got to be such a PITA, that I'm not dropping my G37S. I have only been over a couple of speed bumps since then(taken them at an agle as well) and have not scraped(knock on wood).
On a side note, I see that the two exhaust pips go under the rear axle... seems kinda out of place and possibly prone to a little scrapage. Not sure if the rear diff is lower than those pipes.
That got to be such a PITA, that I'm not dropping my G37S. I have only been over a couple of speed bumps since then(taken them at an agle as well) and have not scraped(knock on wood).

On a side note, I see that the two exhaust pips go under the rear axle... seems kinda out of place and possibly prone to a little scrapage. Not sure if the rear diff is lower than those pipes.

yeahh looking at the pics agian.. its a bit to low for me here in ny especially bx.. but i might do a simple drop maybe take off .2-.4 of an inch what unv dropped.. between the two
Thread
Thread Starter
Forum
Replies
Last Post
misc
Engine, Drivetrain & Forced-Induction
29
May 24, 2023 03:57 PM
sunshineskyler
Engine, Drivetrain & Forced-Induction
4
Nov 13, 2015 09:47 AM




