Rough Idle Running Lean
Rough Idle Running Lean
So i had to put in a new motor, i swapped everything over from the old one i set up the the turbos and everything made sure all the hardware and line are run correctly. i start my car and it runs, it is not running smooth as it should and it is very lean 16 on idle goes down when i throttle i ran for codes and get bank 1 is lean also i think the down pipe on the passenger side might not be fully sealed
It could be a million things really, doubt it's an exhaust leak though.
Do you have a Fuel Pressure gauge? Check your vacuum lines as well. Maybe the new engine flows a lot better than the older one?
You're either seeing more air, or less fuel, or the MAF sensor is not sensing right. Happy Troubleshooting.
Do you have a Fuel Pressure gauge? Check your vacuum lines as well. Maybe the new engine flows a lot better than the older one?
You're either seeing more air, or less fuel, or the MAF sensor is not sensing right. Happy Troubleshooting.
It could be a million things really, doubt it's an exhaust leak though.
Do you have a Fuel Pressure gauge? Check your vacuum lines as well. Maybe the new engine flows a lot better than the older one?
You're either seeing more air, or less fuel, or the MAF sensor is not sensing right. Happy Troubleshooting.
Do you have a Fuel Pressure gauge? Check your vacuum lines as well. Maybe the new engine flows a lot better than the older one?
You're either seeing more air, or less fuel, or the MAF sensor is not sensing right. Happy Troubleshooting.
Thread
Thread Starter
Forum
Replies
Last Post
delfinparis
Audio, Video & Electronics
2
Nov 16, 2015 02:26 PM
dedmanchan
Audio, Video & Electronics
1
Sep 24, 2015 11:25 PM



