Hey everyone, I decided to do a baseline dyno run to get a starting reference point to compare with for future mods. I don't have a stock dyno baseline and I didn't want to remove my Stillen Gen 3's so the results are just for the intakes so far. The car is mostly stock except for my intakes and clutch/flywheel setup. So far no tune yet. I'll definitely get a tune when I get more mods done. My goals are for at least 310+whp with bolt ons and tune, im mighty tempted to save up for a supercharger/TT setup instead for the future.

I went to Turbo Technologies in Tacoma, WA. The guys there are very knowledgeable about tuning/building/racing cars and I learned a lot talking to them. I got to see a 1000hp corvette and a full race corvette. The dyno was performed on a dynojet.

Here's the results:

 

Nice work. Just to see gains. The 290 is a little high IMO tho... But at least you will see what the mods add after.

 

290 is a nice number to start with

 

Good number with intakes.

 

Yeah it definitely has me psyched up on spending more $ on the car haha.