Hi everyone im abit of a newb here so please bare with me as ive tried to search for this question.


All i have for my vehicle setup is Stillen SRI, bout all.
Ive just installed the stage one, is this the right setup? the notes tell me its only for stock intake and exhaust, but all the other maps are for more modded cars, i figuared this was for a more subtle install.

Any input would help,

Thanks all.

 

im currious also, i just picked one up too.

 

stock style map has the best gains.
I was pulling 311whp with stage 2+,based on the mods I have.
stillen stage 3 long tube intake,fi cat back exhaust with fi hfc's.
after my tuner adjusted the air fuel ratio & switch to stock style map.
I pulled 325whp 14whp gain by going back to the stock style map.

throttle 1000x better than stock.

 

cobb is just a piece of junk w/ the basic maps right now

 

What kind of dyno were you using?

 

I hear COBB is not the best... Then I hear BLITZ is not that good either.
What is the best on out there???

I only have the Intakes upgraded right now... I took batter off when installing
so the MAF should learn the new flow. What mods require a special 'Tune'

If the Stock MAP is the best setting, isn't that the one that the car came with?

School my ignorant a$$ please... LOL

 

stock map is the best. cobb is only great with custom maps. the basic maps are the same with all of them uprev and cobb.