What's up guys. So I just recently did a and led swap on my push start and notices that my door kickplate on driver side is out and one 1 works on passenger side. I would like to solder in New lights but don't want to pull the kickplate off more times than I have to. Does anyone know the size of these let's so I can get them on orde?. I will post a diy install after it's done. Thanks guys

 

^
Use you voltmeter!

Telcoman

 

a volt meter isn't going to tell me the size of the leds. I'm trying to only remove the kickplate once because from whst I read they are brittle.

 

I swapped mine out, but they were the illuminated ones. They feel pretty solid to me but like any other trim piece you don't want to force it off too quickly.

 

I'm trying to swap the leds themselves not the whole kickplate