So I got the rear spacers installed with no issues and they look great. when I get to fronts I ran into an issue. Between two of the bolts there is something there. It's hard for me to explain so I will just upload the pic.



What is that and how can I work around it to install my spacer?

Its and H&R 15mm hubcentric spacer.

 

grab a 12mm socket and remove it lol


also, did you TQ the spacer nut's down?

 

I didn't know if I could remove it or not. what is it for?

yeah I torqued them.

 

^
^

What he said!!

 

If the rotor is stuck/rusted to the hub.
You can remove the bolt and spacer, then reinstall the bolt, without the spacer screw it in to pop the rotor loose.

 

like Weiboy said, Its a 12mm bolt installed on the fronts. Its there to ensure some numnut doesn't rotate your wheels; being that the wheels are staggered.

 

Hopefully you didn't bend the wheel studs when you torqued it down. Spray some WD40 and remove those suckers.

 

nah, i don't think i bent them. i torqued them to spec.

Okay well, you all answered my question. Thanks a lot!!

 

NOOOOOOOOO! DO NOT remove that bolt!!








































Kidding, get rid of it.

 

Nooooo! Don't remove it, it's there to hold your brake rotor's in place.......


































Haha, jk.

 

^ Exactly! ... You don't need it, remove it.

 

The rears will still go on with that bolt!!!

 

Sweet! yeah the car i had before this one is a 98 civic, so I've never seen something like this. we learn something new everyday!!