When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Snapped a banjo bolt on the front caliper.
anyone know the torque spec of the banjo bolt?
i think the brake fluid made me over do it.
pls haaalp.
im so close to being done.
Been there done that... On my motorcycle when I installed SS lines. It used a double banjo bolt at the lever master. I used a torque wrench.
Second time around, i used the torque spec good'n'tight. No issues... Sold the bike 5 years later with 80+K miles. 12 ft lb isn't very tight. About as tight as the spec was on the bike I think. Main goal is to keep it from leaking and/or going loose.
I got lucky. When it snapped somehow to torque backout the portion stuck in the caliper and i was able to easly unscrew that. New banjo should be here in the morning.
^^Ditto too. There was a tiny bit of out sticking out. Was around to undo gently by hand. Annoying when you try to follow directions but end up breaking things.
^^Ditto too. There was a tiny bit of out sticking out. Was around to undo gently by hand. Annoying when you try to follow directions but end up breaking things.
thanks for making me feel better.
got this project done finally!
bled the system still feels a bit spongy. Just happy to be rolling again. Will bleed again soon.
