BC Coilover question:
05-28-2008, 03:32 AM
#1
Registered User
Thread Starter
iTrader: (1)
Join Date: Oct 2007
Posts: 134
Likes: 0
Received 0 Likes
on
0 Posts
BC Coilover question:
Got them installed a couple of weeks ago, and the back end rattles, when going over bumps.
The shop I got them installed from said that it was because of the spring design being metal on metal.
I dunno
but I want it gone. What do you guys think?
Thanks
The shop I got them installed from said that it was because of the spring design being metal on metal.
I dunno
but I want it gone. What do you guys think?Thanks
05-28-2008, 09:16 AM
#5
Registered User
Join Date: Sep 2005
Location: Augusta, GA
Posts: 1,664
Likes: 0
Received 0 Likes
on
0 Posts
and actually.. the spring shouldn't be touching any metal now that i think about it. did they put them in right?
the cone-shaped top coil perch comes out and gets replaced with the piece that came with the coilovers (pretty sure it had rubber on it)
and the bottom rubber piece gets taken off of the old spring and put on the new one
i'd check and make sure all the bolts were tight too
the cone-shaped top coil perch comes out and gets replaced with the piece that came with the coilovers (pretty sure it had rubber on it)
and the bottom rubber piece gets taken off of the old spring and put on the new one
i'd check and make sure all the bolts were tight too
Last edited by IP37; 05-28-2008 at 09:22 AM.
Trending Topics
05-28-2008, 10:18 PM
#8
Glad I'm not the only one with the rear right rattle...it sounds like something loose and is ANNOYING! I thought it was my seat not fully latched or the seat belt in the back hitting the trim, but it is neither. Sadly I noticed that with a passenger the noise goes away, making this really difficult to resolve. Let me know what you find Max.
