When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I rubbed off the layer as shown in the picture, what can I do to resume it or make it look better? Pls give some advice
easiest solution is to vynil wrap it. 3M has many metal-like opinion.
If youre very good at finishing work, wet-sanding and buffing in the direction of the aluminium brush can Repair it... But you'll likely have to sand the entire plate to make it look good and cohesive. Lots of tedious hours of unidirectional sanding
easiest solution is to vynil wrap it. 3M has many metal-like opinion.
If youre very good at finishing work, wet-sanding and buffing in the direction of the aluminium brush can Repair it... But you'll likely have to sand the entire plate to make it look good and cohesive. Lots of tedious hours of unidirectional sanding
I don't think it's a brushed finish. It looks more like something that's painted over the top of the bare aluminum. Apparently it's supposed to resemble traditional Japanese washi paper.