I need to replace the OEM HID for a high power LED. I managed to get a set of D2S mount LED for the headlight. But the LED need a regular 12V to power on.

So far, the best way I could think of is, remove bumper > remove headlight housing >remove the ballast> cut off the input wire to get 12V for headlight.

Is there a better way to do it? Like direct wiring to the LED headlight to power terminal? If there is the case, 1 problem, there are 2 terminals for each side of headlight, high and low beam, total 4 plus negative.

what you think?

thanks ahead
Vic

 

That's easiest way that way your not fighting for room going through the tire well