Hey fellas,

Has anyone done an install of a switchback LED front turn signals?

I'm looking to purchase this one but really have no idea what the install process is like:
V3 TRITON GEN 2.5 WHITE AMBER LED SWITCHBACK SYSTEM 7440 | 1 SET - 7440 - Turn Signals Front - Shop Bulb Type

Does the install require any wire cutting/soldering?

 

I did it with another company's product and, yes, there was cutting. In order to use LEDs without hyper-flashing you need to install load resistors. They're spliced into the turn signal wires.

It's not real difficult. There are some DIYs on here with tips/etc. Some of the distributors have instructions on their sites.

Sean

 

Unfortunately I still have warranty on my car and would rather not cut any wires.. That sucks

 

I, too, have a warranty. But warranties are made to be broken....

And in my defense, it was more of a wire stripping than a wire cutting....

Sean

 

There is no cutting involved with the V3 Triton. The resistor is built in so it is a 100% plug and play solution.

 

agreed, I have them and man what an awesome investment! I didn't care for the "switchback" mode as I like the clean amber look but boy was I happy with the results! Great job VLED's!