Replaced running lights and fog lamps and my 2011 g37 and turned on service engine light. Do I need load resistors? Any help would be greatly appreciated.

 

I would get your codes check and make sure the issue really is the lights. It's possible you might need a CANBUS adapter, but I doubt it. If you did a retrofit, it's also possible you need a relay harness.

 

No. Look into connections for your intake tubes/setup.

 

I did start it with the intake tubes off/wire disconnected to check the lights before putting them back in

 

Oh, yeah. Just reset your ECU. If you leave your MAF sensors unplugged your car will idle roughly and throw lights. I made that mistake. Just disconnect the negative terminal of your battery for a few minutes and reconnect it.

 

BINGOOOOO, IT'S YOU INTAKES LOL , line them up carefully and if light doesnt go away remove battery cables for 30min and re plug Problem solved BUT realign intakes

Had the same issue a week ago Super Annoying

 

thank you guys for your input!!!! any idea's for me as far as putting different intakes on brand etc....

 

stillen gen3 cai is the best bang for your buck....