I recently bought a decal vinyl cutter and some carbon fiber vinyl. After making some decals... I decided to give CF wrap a try and below is the result after 4 hours for first attempt. I do realize the pattern was not consistent all the way down and did not realize it until It was too late. I still need to finish wrapping the area above the shift ****.. but i couldn't get the **** off. So i will try again later. Let me know what ya'll think!

 

Aside from the pattern not matching all the way down, great attention to details. Nicely done.

 

They messed up the pattern on mine so i made them redo it. i felt bad but it looks a lot better so it was worth it

 

yes nicely done

 

Just finished wrapping the rest of the panels and re-wrapped the lower center console so the patterns would match.. took forever!

 

I did all mine the same, but managed to pull the area you have not done over the gear **** to wrap it, check out jamesdale2000 photo.