Confused about Auto up/down rear windows
Thread Starter
Registered Member
iTrader: (2)
Joined: Oct 2009
Posts: 191
Likes: 6
From: West Covina, California, USA
Confused about Auto up/down rear windows
I have question regarding the premium package. I purchased a 2009 G37 Journey sedan with premium package. To my understanding the rear windows have the auto up/down feature. I can lower my rear windows automatically but I can not raise them automatically. Am I missing this feature? On the window sticker it listed the auto up/down feature for the rear windows in addition to the front windows as part of the premium package. Anyone else experiencing this as well? Please let me know as I think I have to go back to the dealership and let them know someone forget to install that feature on my vehicle. 
Registered User
Joined: Oct 2009
Posts: 35
Likes: 0
From: Georgia
They work for me.
I have the same vehicle and have no problem. Auto up/down works on all windows. Just used all four yesterday to get the heat out of the car after it sat in the parking lot all day at work.
Note: I raised and lowered them from the Drivers controls. I have not sat in the back seat and tried.
Note: I raised and lowered them from the Drivers controls. I have not sat in the back seat and tried.
Last edited by Master Chief; Oct 22, 2009 at 07:40 AM. Reason: Added Note
Registered User
Joined: Mar 2008
Posts: 970
Likes: 40
From: Kuwait
15sec is too much. 8-10 is enough. Some even say 5 sec is enough.
With the windows half way down, fully press the button up or down (whichever way you choose first) and wait for 8-10 seconds. Do the same for the other direction and for all affected windows.
With the windows half way down, fully press the button up or down (whichever way you choose first) and wait for 8-10 seconds. Do the same for the other direction and for all affected windows.
From page 2-51 of the obscure, little know "owner's manual". It is a rare, seldom seen document of antiquity that many claim is only a myth.
Originally Posted by TFM
If the windows do not close
automatically
If the power window automatic function (closing
only) does not operate properly, perform the
following procedure to initialize the power window
system.
1. Push the ignition switch to the ON position.
2. Close the door.
3. Open the window more than halfway by
operating the power window switch.
4. Pull the power window switch and hold it to
close the window, and then hold the switch
more than 3 seconds after the window is
closed completely.
5. Release the power window switch. Operate
the window by the automatic function to
confirm the initialization is complete.
6. Perform steps 2 through 5 above for other
windows.
If the power window automatic function does
not operate properly after performing the procedure
above, have your vehicle checked by an
INFINITI dealer.
automatically
If the power window automatic function (closing
only) does not operate properly, perform the
following procedure to initialize the power window
system.
1. Push the ignition switch to the ON position.
2. Close the door.
3. Open the window more than halfway by
operating the power window switch.
4. Pull the power window switch and hold it to
close the window, and then hold the switch
more than 3 seconds after the window is
closed completely.
5. Release the power window switch. Operate
the window by the automatic function to
confirm the initialization is complete.
6. Perform steps 2 through 5 above for other
windows.
If the power window automatic function does
not operate properly after performing the procedure
above, have your vehicle checked by an
INFINITI dealer.
Trending Topics
Registered User
Joined: Jan 2009
Posts: 382
Likes: 3
Yea...holding switches for 15 seconds is BAD for the motors. I made a window operate very slowly after doing that. It was fine after the motor cooled a bit but it had me scared. Follow the nissan procedure above!
Thread
Thread Starter
Forum
Replies
Last Post
Chris Olson
Audio, Video & Electronics
17
Dec 29, 2025 07:59 PM
