Hi!

I know this topic has been covered a few times, so please delete if not allowed.

But I am actually trying to figure out the wiring diagram to my YAW sensor on my 2008 Infiniti G35 S Sedan. I would like to splice a switch onto the signal/accessory wire rather than the power, I am avoiding the need to use a fuse or relay and just want to cut the signal instead of power.

Been having trouble finding a wiring diagram and would love some assistance, here is image of the switch and the wire colors:




Thanks in advance!

 

https://www.myg37.com/forums/d-i-y-i...n-control.html

 

Thanks for the link!

I think I did end up on this thread - just was not sure what the 'green' wire actually was. It wasn't mentioned in the thread if it was power or what not. But seems like everyone is splicing that with no fuse.

 

Hey I responded to the PM.

FYI there's the Yaw only has one single power input which is ignition. Unless you plan on cutting ground, cutting power is the only way to go.

 

Perfect - Thanks BULL your PM helped me out a lot.

for anyone else:

Yaw Sensor:
Green - Ground
Grey - 12V