Blinking airbag light after sub/amp install
#1
Blinking airbag light after sub/amp install
Just like the title says I got my sub and amp professionally installed (in my 4080) drove it home, reset the windows and noticed a blinking airbag light on the dash. Is there anyway to fix it without going to the dealership. The closest one is 1 1/2 hrs away in Santa Barbara. I dont want to go there and have them charge me after they notice my after market stuff.
#4
Registered Member
I had the same problem, what happened was that I some how touched an airbag connector and it got lose. All yellow connectors are air bag connectors.
I figured this out, by taking it to the dealer because first I had no idea what was going on... they ran the consult and it pointed exactly to the one connector, plugged it back in and all good. Except they charged me $60 but I guess it was my own fault.
I figured this out, by taking it to the dealer because first I had no idea what was going on... they ran the consult and it pointed exactly to the one connector, plugged it back in and all good. Except they charged me $60 but I guess it was my own fault.
#7
How did someone touch an airbag sensor wire while installing an amp and sub? They are not even on the same wirinf harness?
Trending Topics
#8
Ya im not sure. They said our cars are a real PITA to work on. Then they said it happens with all nissan/infinitis that the airbag sensors go off. Im not that technical so i couldnt exactly call them on their sh*t but I think they didn't know what they were doing.
Thread
Thread Starter
Forum
Replies
Last Post
superjoey
D.I.Y. Installations/Modifications
31
03-22-2023 11:56 PM