Aftermarket amp and sub installation
Registered User
Joined: Apr 2008
Posts: 26
Likes: 0
4 gauge is likely not heavy enough power wire IMO to supply curent to multiple amps pushing 2500 watts RMS. I'd go overkill with the 0, that leaves no doubt that maybe it coulda/shoulda been bigger.
I like car audio too. I just prefer to keep it simple. For my ears more speakers is generally worse, not better. I'll end up running only a single set of 2 way or possibly 3 way (still undecided) components in the front stage and a pair of 10" subs (when 4080 gets around to producing the passsenger side enclosure) all powered from one or 2 amps.
What speakers/subs/amps are you going with?
Good luck with your setup. I'd love to hear it when we have our 1st annual national G37 meet.
I like car audio too. I just prefer to keep it simple. For my ears more speakers is generally worse, not better. I'll end up running only a single set of 2 way or possibly 3 way (still undecided) components in the front stage and a pair of 10" subs (when 4080 gets around to producing the passsenger side enclosure) all powered from one or 2 amps.
What speakers/subs/amps are you going with?
Good luck with your setup. I'd love to hear it when we have our 1st annual national G37 meet.
+ 1
Suggestion. Look into Stinger XPERT FLAT zero gauge wire. its a bit easier to run along corners, also very flexible. If you want overkill they make a 3x 0 (triple zero ) gauge if you think you might need it.
Last edited by Lou@Amplified; May 6, 2008 at 04:39 PM.
Registered User
Joined: Apr 2008
Posts: 26
Likes: 0
you might wanna try this site, they make good Amplifier Installation Kits
here is the link.
http://www.knukonceptz.com/productDe...prodID=KLM-AK0
or this
http://www.knukonceptz.com/productDe...prodID=KOL-AK0
(this is the one i use)
here is the link.
http://www.knukonceptz.com/productDe...prodID=KLM-AK0
or this
http://www.knukonceptz.com/productDe...prodID=KOL-AK0
(this is the one i use)
Thread
Thread Starter
Forum
Replies
Last Post
