2012 G37 Sedan Base Catback exhaust on budget
#16
Registered Member
Thread Starter
Pulled this off my dashcam.... just cruising around part throttle in the vid. I did merge onto the highway at WOT in one clip but i had the radio on so I didn't include it.
https://youtu.be/tR9HXeDr6OA
Tanabe medallion + 12" vibrants
https://youtu.be/tR9HXeDr6OA
Tanabe medallion + 12" vibrants
The following users liked this post:
iCrap (09-27-2017)
#17
Do you have a pic of the vibrant resonators?
I have the Tanabe axleback and have been trying to figure out where to put the vibrant resonators if you could post a pic, that would be very helpful.
I have the Tanabe axleback and have been trying to figure out where to put the vibrant resonators if you could post a pic, that would be very helpful.
#18
Administrator
iTrader: (9)
Pulled this off my dashcam.... just cruising around part throttle in the vid. I did merge onto the highway at WOT in one clip but i had the radio on so I didn't include it.
https://youtu.be/tR9HXeDr6OA
Tanabe medallion + 12" vibrants
https://youtu.be/tR9HXeDr6OA
Tanabe medallion + 12" vibrants
I mean, I don't disagree with you that it would sound a little bit nicer if it were just a little bit deeper tone, but there's nothing wrong with what you have here at all.
Verywell done, iCrap.
The following users liked this post:
iCrap (09-27-2017)
#20
Registered User
Exhaust design is very tough, and opinions on exhaust vary a lot. I would try and find some local G37/370Z folks and hear their setups... that's the only way you can know for sure.
The following users liked this post:
Lee Nguyen (09-27-2017)
#23
Vibrant 3" X 12" INCH Stainless Steel Resonator 1794 | eBay
#24
Registered Member
iTrader: (8)
Is there any specific part number to the vibrant resonators. I live in Dubai and would be paying about 80 dollars in shipping so want to be 100% sure that I am ordering the right part. I did find a few options but not sure what diameter I should be ordering, would 3-inch work or I should stick to 2.5
Vibrant 3" X 12" INCH Stainless Steel Resonator 1794 | eBay
Vibrant 3" X 12" INCH Stainless Steel Resonator 1794 | eBay
No, you need the correct size for the exisiting piping. it's Vibrant 1790
#25
Registered Member
Pulled this off my dashcam.... just cruising around part throttle in the vid. I did merge onto the highway at WOT in one clip but i had the radio on so I didn't include it.
https://youtu.be/tR9HXeDr6OA
Tanabe medallion + 12" vibrants
https://youtu.be/tR9HXeDr6OA
Tanabe medallion + 12" vibrants
#27
Registered Member
iTrader: (2)
Imo, the Top Speed isn't too loud either. Maybe on cold starts though. You can baby the throttle to keep it quiet for sure. I actually was severely missing my ART pipes when I had them out to pass smog, the Top Speed and an aftermarket y pipe were too quiet for me by themselves.