That said, I do like the CS version of the bumper better. Do you know what they charge for the bumper? Bet it would cost a fortune to have it shipped to the US though!

 

Man not sure try emailing then or I will check and email you. check with them on CarbonSignal Automotive - CarbonSignal Automotive

 

Cool. Thanks. I might be interested in the side skirts in CF.

Also, are you running a rear roof spoiler on your G? If so, which one?

 

SEXY!!

I was wondering how did you blackout the grille? If you buy the midnight grille, how do you get rid of the silver surroundings?

 

Would you mind sharing your camber settings? Is that about -2.5 in the rear? What about the front? I am thinking of getting similar spec wheels. Thanks!

 

That 4th shot is MONEY!!!! looks nice! even on those green wheels lol! Those wheels don't look good in black at all.

Honestly don't like those wheels at all.

 

I'm not sure what camber settings Docaam is running, but thought this might help you a little... I'm running 20x10.5 +43 with 285/30R20's and -2.7° camber in the rear and 20x9.5 +25 (+35 with 10mm spacer) with 245/35R20's and -1.5° camber up front.

 

Your G is FIRE! Great build process... Big Props to you man.

 

I got it from them, when took the kit was cheap i guess 70$ or something

I painted it, outer part is CF wrapped middle is painted.

Front -1.6 and -2.1 at the back.

Thanks man

 

Some little upgrades on the car done

My stock cats were rubbing everywhere




so changed the cats and Y pipe

Megan Y pipe





and CNT resonated TPs





I had to cut half an inch and moved the TPs a bit up now rubbing is quiet a less.

I had Tanabe Axle back installed so sound is much better with little improvement in performance as well with no rasp and drone. Its a bit difficult here to drive a sedan with loud exhaust so it will stay below the cops radar.

Nest thinking of doing something to the interior

 

Nice updates!

I'm currently running BERK HFC's with Invidia x-pipe/resonators and Tanabe axle back. Although this set-up sounds great it is a little loud IMO, so I'm thinking of going to a similar set-up as yours and run a Tanabe Y-Pipe with the factory resonators and Tanabe axle back. Although I noticed that the Megan Y-Pipe is much cheaper than the Tanabe. What did you think of the quality of the Mega Y-Pipe?

 

Its not that loud and rasy, but hiss is there. Megan pipe seems to be a good quality though wont be like Tanabe, but for G wasn't thinking of spending much, money pit is going through an engine swap so funds moved there

 

Thanks for the info.

I though you already did the engine swap on the S30. You doing one on the Z now?

 

I did RB25 earlier when restoring it, but now changing it to VQ30DET

 

Just go RB26DETT already