I've seen also Eibachs w 20/25 and 235/35 265/30 W out rubbing. 275s I have yet to see w Eibachs drop . Just one guy on S techs that pulled it off at +25 w 275s and that was low but he modIfied his rear brackets and never rubs , I think u will b ok just test it out. Worst case u trim your rear bracket and u will b good to go.

 

got it, ill keep that in mind

 

I am on 275's at +23 and my car is very low on BC's and around -1.5 neg camber but I removed the liner, shaved the **** out of my bumper bracket and even pulled my fender about 2-3 more mm.

 

Damn lol all good , but you pulled the Fenders ??? Idk if i could handle doing that , but fender liner and bracket should be ok to remove . Damn Kid any pics of your Rears ?? i wanna see.

 

I dont have any good pics where you can really see it. I will try to snap one later on my phone and post it.

Edit: Found a couple. Sorry for the thread jack!

This was before I lowered it a little more and pulled the fender.



This is after I dropped it further but still no pulled fender.

 

Dam^ Your at 10.5 +23 right there^^^and 275/30 what tire brand??

 

Looks good, I see slight camber! Either way that more or less what OP would be considering cause it may look similar just not as low. Thanks for the pics Kid!!!

 

It came out nice!! I hope I don't have to go through all that trouble to lower mine

 

Kid post some pics of the fender pull, Ive never seen one done on a G, or pm me, i didnt mean to thread jack lol. But ya op post a photo of your cars lets see it

 

it's all right i wanna see the pics too, i might give me an idea of what i can do in case I run into problems when lowering mine

 

Thanks guys. Busy weekend. I will try to snap a pic today and post it later.

 

Very informative thread.

 

Yes it is, thank you for all the support guys!

 

OK well this is just about the worst pic ever but you may be able to see where I pulled the fender. It is literally only a few mm so barely noticable but just needed that little more to keep it from rubbing. If you look there is a slight crease near the edge where it flares out a tad. I used a tool made for rolling fenders and heat gun.

 

Looks great